Peel the top layer off to expose the ends.
12v led light strip installation.
Wire the controller or lights directly to a power source of 12v and ground mount the light strips securely test and verify operation.
A video showing the installation of an led light strip under the awning on our rv.
I was able to do this without any drilling into the tailer by utilizing th.
You ll need to plan to do the following.
Slide the end of the strip into one end of a connector clip and snap it shut.
This means that all of the red wires will be connected together to run to the switch.
Installation tool list for 12v led light strips the tools you need for a complete installation are below.
Use a sharp knife to make a slit along the black lines between the light and the end of the led strip.
3 insert strip light into the connector so that the connector teeth will insert into the bottom of the strip light.
Wire multiple strips of lights together.
Lights will have a pair of red and black wires coming from them.
Led strip mounting clips mounting brackets for strips.
Fitting led strip lighting on an rv awning is a perfect eco friendly solution to illuminating the exterior of your unit and to make the most of the camping experience using led lights rather than traditional lighting reduces your carbon footprint they re easier to install and versatile.
To get started with your diy 12v led light strip installation you need some tools.
1 2 peel back the adhesive tape backing enough to accommodate the connector.
Now you could also want full on waterproof led strip lights ip67 if your lights are anywhere near your boats outer edge or even on the hull itself.
In these situations use one of the following.
Start by wiring all strips or strings of lights together.
Place a connector in the other side of the clip so the strip can lay flush along the corners.
One or two reels of 12v led light strips you may need more depending on the project.
Extra adhesive tape 3m tape that you put on the surface before the strip to double the bond.